User guide

Security command reference Security
4-79
iMG/RG Software Reference Manual (IPNetwork Functions)
2 | i2 | external
3 | i3 | dmz
---------------------------
See also SECURITY SHOW INTERFACE
4.2.7.1.15 SECURITY SHOW INTERFACE
Syntax SECURITY SHOW INTERFACE <name>
Description This command displays information about a single interface that was added to the Secu-
rity package using the security add interface command. The following interface informa-
tion is displayed:
•Interface name
• Interface type (external, internal or DMZ)
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Example --> security show interface f2
Interface name: f2
Interface type: internal
See also SECURITY LIST INTERFACES
4.2.7.1.16 SECURITY ADD MGMT-STATION RANGE
Syntax SECURITY ADD MGMT-STATION <name> {RANGE <start_addr>
<end_addr> | SUBNET <address> <mask> } <transport_type>
<port> <idle_timeout>
Description This command creates a Management Station that allows a specific host (or range of
hosts) to access your device directly, bypassing NAT and Firewall. IP packets from a
Management Station are sent to the external interface (WAN) using a specific transport
and port number. The Management Station is not enabled until you enable it using
SECURITY SET MGMT-STATION.
Option Description Default Value
name An existing security interface. To display all interface
names, use the security list interfaces command.
N/A