User guide

Security command reference Security
4-73
iMG/RG Software Reference Manual (IPNetwork Functions)
Example --> security enable blockinglog consoleprinting
4.2.7.1.4 SECURITY SET BLOCKINGLOG|INTRUSIONLOG|SESSIONLOG LEVEL
Syntax
security set {blockinglog | intrusionlog | sessionlog} <level>
DescriptionFor each logging event it’s possible set the minimum level of logging that is reported. The levels
available in this command correspond to syslog levels (emergency, alert, critical, error, warning, notice, informa-
tional, debug).
The default reporting level for an enabled log activity is notice, which will report emer-
gency, alert, critical, error, warning and notice messages but not the informational or
debug messages.
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Option Description Default Value
enabled The specified logging activity is displayed at the console. Disable
disabled The specified logging activity is sent to the event log.
blockinglog Specifies where blocking activity is displayed. N/A
intrusionlog Specifies where intrusion activity is displayed..
sessionlog Specifies where session activity is displayed.
consoleprinting Enabling consoleprinting sends logging to the console
instead of to the event log. Disabling consoleprinting
sends logging to the event log instead of to the console.
N/A
Option Description Default Value
blockinglog Configures blocking logging. N/A
intrusionlog Configures intrusion logging. N/A
sessionlog Configures session event logging. N/A