User guide

System Management Command Line Interface and Console
iMG/RG Software Reference Manual (System Configuration)
1-4
To create new user accounts, use the SYSTEM ADD USER or SYSTEM ADD LOGIN commands. The accounts created
by these commands default to low privileges.
To change user privileges, use the
SYSTEM SET USER ACCESS or SYSTEM SET LOGIN ACCESS commands.
To list the current user or login accounts, use the
SYSTEM LIST USER or SYSTEM LIST LOGIN commands, respec-
tively.
The user-related commands are details in Section 1.1.5
1.1.2.2 Access permissions to WEB interface
Similarly to CLI permission, the access to WEB interface is controlled by the user access level and by the may-
configureweb flag:
• Default user - can access to Status pages, Wireless configuration and user password settings. Cannot access
to the other configuration pages.
• Engineer or Super user - can access to Status , Wireless configuration, Security configuration, firmware
upgrade pages.
The following table maps the user properties to the corresponding WEB credentials. User properties can be
configured via CLI commands by setting the user access level (default, engineer, administrator) and the mayconfig-
ureweb flag (enabled, disabled).
superuser disabled No access to CLI
superuser enabled Full CLI commands access (read and write operations)
access
level
mayConfigureWeb Allowed CLI operations
default disabled No access to WEB interface
default enabled Status pages,
Statistics,
Wireless settings (basic & advanced),
User password change
Configuration saving
engineer/
superuser
disabled No access to WEB interface
access
level
mayConfigure Allowed CLI operations