User guide

TCP/IP command reference IP
4-47
iMG/RG Software Reference Manual (IPNetwork Functions)
4.1.8.2.51 IP SET RIP AUTHENTICATION
Syntax ip set rip authentication {enabled | disabled}
Description This command enables/disables RIP v2 plain text authentication.
If enabled, a plain text authentication string is placed in RIP v2 packets. RIP v2 packets will
only be accepted if they contain an authentication entry with the correct password string.
Packets with no authentication or the wrong password will be rejected.
To set an authentication password, use the IP SET RIP PASSWORD command.
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Example --> ip set rip authentication enabled
See also ip set rip password
ip show
4.1.8.2.52 IP SET RIP DEFAULTROUTECOST
Syntax IP SET RIP DEFAULTROUTECOST <cost>
Description This command sets the number of hops counted as the cost of a default route advertised
via RIP.
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Example --> ip set rip defaultroutecost 10
See also IP ADD DEFAULTROUTE GATEWAY
IP ADD DEFAULTROUTE INTERFACE
IP SET RIP ADVERTISEDEFAULT
IP SET ROUTE ADVERTISE
4.1.8.2.53 IP SET RIP HOSTROUTES
Syntax ip set rip hostroutes {enabled | disabled}
Description Specifies whether IP interfaces will accept RIP routes to specific routes.
Option Description Default Value
cost The number of hops counted as the cost of the default
route. It can be any positive integer between 1 and 15.
1