User guide

IGMP snooping IGMP Snooping command reference
iMG/RG Software Reference Manual (IGMP)
3-36
3.1.5.1.37 IGMP SNOOPING SET LEAVETIME
Syntax IGMP SNOOPING SET LEAVETIME <leavetime>
Description This command sets the duration of the Leave Period timer for the IGMP snooping pro-
cess. The timer controls the maximum allowed time before hosts must send a response
to Query message issued by the Gateway.
When IGMP snooping is enabled, by default this value is set to 10 sec.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example ◊ igmp snooping set leavetime 50
See also IGMP SNOOPING ENABLE
3.1.5.1.38 IGMP SNOOPING SET TIMEOUT
Syntax IGMP SNOOPING SET TIMEOUT <timeout>
Description This command sets the longest interval, in seconds, for which a group will remain in the
local multicast group database without the Residential Gateway receiving a Host Member-
ship Report for this multicast group.
When IGMP snooping is enabled, by default this value is set to 270 sec.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example igmp snooping set timeout 125
See also IGMP SNOOPING ENABLE
Option Description Default value
leavetime The leavetime value expressed in seconds. Valid values are
between 0 and 65535.
10
Option Description Default value
timeout The timeout interval value expressed in seconds. Valid val-
ues are from 1 to 65535.
270