User guide

IGMP Snooping command reference IGMP snooping
3-25
iMG/RG Software Reference Manual (IGMP)
3.1.5.1.14 BRIDGE SET IGMPSNOOP NETINTERFACE
Syntax BRIDGE SET IGMPSNOOP NETINTERFACE <ip interface name>
Description This command specifies the IP interface from which IGMP proxy messages should be
sourced. Uses IP address 0.0.0.0 if not specified.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> bridge set igmpsnoop netinterface ip0
See also IP LIST INTERFACES
3.1.5.1.15 BRIDGE SET IGMPSNOOP QUERYINTVL
Syntax BRIDGE SET IGMPSNOOP QUERYINTVL < queryintvl >
Description This command sets the value for the query interval. The Query Interval is the time
between General Queries sent by the proxy Querier.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> bridge set igmpsnoop queryintvl 200
See also BRIDGE SHOW
BRIDGE SET IGMPSNOOP QUERYRESPONSEINTVL
3.1.5.1.16 BRIDGE SET IGMPSNOOP QUERYRESPONSEINTVL
Syntax BRIDGE SET IGMPSNOOP QUERYRESPONSEINTVL < queryresponseintvl
>
Option Description Default value
Name A name that identifies an existing ip interface as seen
with ip list interfaces
ip0
Option Description Default value
Queryintvl The query interval value in seconds. Query interval
cannot be less than or equal to the query response
interval. Valid range is 2 to 255
125