User guide

VLAN command reference VLAN
2-107
iMG/RG Software Reference Manual (Switching)
Description This command defines a new VLAN that has the specified VID value.
The VLAN name can be 16 characters length; it cannot start with a digit and cannot con-
tain dots '.' or the slash symbols '/'.
This command specifies also the priority value of the tagged packets that from the net-
work processor are sent to the layer 2 switch and then to the network.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example vlan add voip vid 10 802.1p_priority 7
See also VLAN SHOW
2.4.4.1.20 VLAN CLEAR
Syntax VLAN CLEAR < vlanname >
Description This command removes an existing vlan from the vlan database.
Name Description Default Value
vlanname An arbitrary name that identifies the VLAN. The
name must not be already in use for another
VLAN. The VLAN name can be at most 16 chars
long.
N/A
vlanID The VLANID parameter specifies a unique VLAN
Identifier (VID) for the VLAN.
If tagged ports are added to this VLAN, the speci-
fied VID is used in the VID field of the tag in out-
going frames.
If untagged ports are added to this VLAN, the
specified VID only acts as an identifier for the
VLAN in the Forwarding Database. The default
port based VLAN has a VID of 1.
N/A
priority It's the priority value as defined in 802.1p of the
tagged packets that from the Residential Gateway
network processor are sent to the switch and
then outside to the network. Available values are
in the range 0 to 7.
0