User guide

Bridge command reference BRIDGE
2-79
iMG/RG Software Reference Manual (Switching)
• Filter Type: The type of Ethernet filtering performed by the named bridge interface,
by default it is set to All.
• Port Filter: The list of bridge interfaces that the frames can go through, if the frames
are received on this bridge interface.
• Transport: The name of the transport attached to the bridge using the bridge attach
CLI command.
• PVID: Port VLAN ID associated with the interface.
• Acceptable Frame Type: Acceptable Frame Type Setting which is non-configurable
and always enabled, i.e. each bridge interface can be configured to accept all frames
or only tagged frames.
• User Priority: Default User Priority.
• Leave Mode: IGMP Snoop Leave Processing mode.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> bridge show interface bridge1
Filtering entries for the FDB: FDB_1
ID| Type | MAC Address | Receive Port
--------------------------------------------------------
1| Dest Static| 0:0:0:0:0:0 |
Egress Interfaces: bridge1
---------------------------------------------------------
See also BRIDGE ADD UCASTENTRY SRC
BRIDGE ADD UCASTENTRY DEST
BRIDGE LIST STATIC UCASTENTRIES
BRIDGE ADD VLAN
2.3.4.1.53 BRIDGE SHOW INTERFACE REGENPRIORITY
Syntax BRIDGE SHOW INTERFACE {<name>|<number>} REGENPRIORITY
Description This command adds a named interface to the bridge.
Name Description Default Value
Name The name manually assigned to the object when it was
created.
N/A
Number The numerical identifier automatically assigned to the object
when it was created.
N/A