User guide

BRIDGE Bridge command reference
iMG/RG Software Reference Manual (Switching)
2-76
Example --> bridge set interface bridge1 regenpriority 3 2 4 0 0 0 0 0
See also BRIDGE SHOW INTERFACE REGENPRIORITY
BRIDGE LIST INTERFACES
2.3.4.1.47 BRIDGE SET INTERFACE TRAFFICCLASSTATUS
Syntax
BRIDGE SET TRAFFICCLASSSTATUS { enable | disable | prioritybased }
Description This command specifies the mapping of regenerated priority to their traffic class values.
See bridge show interface trafficclassmap to see the traffic class mapping.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> bridge set trafficclassstatus enable
pri1 The regenerated user-priority to which the user priority with
value 1 in the incoming frame should be mapped.
1
pri2 The regenerated user-priority to which the user priority with
value 2 in the incoming frame should be mapped.
2
pri3 The regenerated user-priority to which the user priority with
value 3 in the incoming frame should be mapped.
3
pri4 The regenerated user-priority to which the user priority with
value 4 in the incoming frame should be mapped.
4
pri5 The regenerated user-priority to which the user priority with
value 5 in the incoming frame should be mapped.
5
pri6 The regenerated user-priority to which the user priority with
value 6 in the incoming frame should be mapped.
6
pri7 The regenerated user-priority to which the user priority with
value 7 in the incoming frame should be mapped.
7
Name Description Default Value
Enable Enable the mapping of regenerated priority to its traffic
class.
Disable
Disable Disable the mapping of regenerated priority to its traffic
class.
Prioritybased Traffic class mapping would happen only if traffic class has
not been already set.
Name Description Default Value