User guide
Switch command reference Switching
2-29
iMG/RG Software Reference Manual (Switching)
Example --> switch set port lan1 speed 10F
See also SWITCH SHOW PORT
2.2.4.1.35 SWITCH SET PORT STATUS
Syntax SWITCH SET PORT <portname> STATUS { Enabled | Disabled }
Description This command disables or enables the switch port.
To show the current port status, use the SWITCH SHOW PORT command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> switch set port lan1 status Disabled
2.2.4.1.36 SWITCH SET PORT TRSLIMIT
Syntax SWITCH SET PORT <portname> TRSLIMIT < trslimit >
Description This command specifies the ingress data rate limit. These limits apply to all frame types
entering on the selected switch port.
To show the current port status, use the SWITCH SHOW PORT command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> switch set port lan1 trslimit 8Mbps
Option Description Default Value
portname he name of the switch port to be configured.
See Section 2.3 for a list of possible port names.
N/A
Enabled | Disabled When Enabled, the link is up and traffic can be sent
or received to/from the switch port.
When Disabled, the link is forced to be down.
Enabled
Option Description Default Value
portname he name of the switch port to be configured.
See Section 2.3 for a list of possible port names.
N/A
trslimit The maximum bit rate allowed on a switch port in
the transmit direction. See Section 2.3 for a list of
possible values - depending on product family.
None