User guide

Switching Switch command reference
iMG/RG Software Reference Manual (Switching)
2-28
Description This command specifies the ingress data rate limitfor the low priority traffic. These limits
apply to all frame types entering on the selected switch port that are categorized as low
prirority.
To show the current port status, use the SWITCH SHOW PORT command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> switch set port lan8 rcvlimit-low 4Mbps
2.2.4.1.34 SWITCH SET PORT SPEED
Syntax SWITCH SET PORT <portname> SPEED <port-speed>
Description This command set the speed value and mode on the selected switch port.
To show the current port status, use the SWITCH SHOW PORT command.
Options The following table gives the range of values for each option which can be specified with
this command and a default value (if applicable).
Option Description Default Value
port-name The name of the switch port to be configured.
See Section 2.3 for a list of possible port names.
N/A
rcvlimit The maximum bit rate allowed on a switch port in
the receive direction. See Section 2.3 for a list of
possible values - depending on product family.
None
Option Description Default Value
Port-name The name of the switch port to be configured. See
Section 2.3 for a list of possible port names.
N/A
port-speed The port speed and mode. Allowed values are:
AUTO (Autonegotiate)
COAX (10Mbps Half Duplex)
10H (10Mbps Half Duplex)
10F (10Mbps Full Duplex)
100H (100Mbps Half Duplex)
100F (100Mbps Full Duplex)
1000H (1000Mbps Half Duplex)
1000F (1000Mbps Full Duplex)
AUTO