User guide

Switch command reference Switching
2-27
iMG/RG Software Reference Manual (Switching)
Description This command specifies the ingress data rate limit. These limits apply to all frame types
entering on the selected switch port.
To show the current port status, use the SWITCH SHOW PORT command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> switch set port lan8 rcvlimit 4Mbps
2.2.4.1.32 SWITCH SET PORT RCVLIMIT-HIGH
Syntax SWITCH SET PORT <portname> RCVLIMIT-HIGH < rcvlimit >
Description This command specifies the ingress data rate limit for high priority traffic. These limits
apply to all frame types entering on the selected switch port that are high priority.
To show the current port status, use the SWITCH SHOW PORT command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> switch set port lan8 rcvlimit-high 4Mbps
2.2.4.1.33 SWITCH SET PORT RCVLIMIT-LOW
Syntax SWITCH SET PORT <portname> RCVLIMIT-LOW < rcvlimit >
Option Description Default Value
port-name The name of the switch port to be configured.
See Section 2.3 for a list of possible port names.
N/A
rcvlimit The maximum bit rate allowed on a switch port in
the receive direction. See Section 2.3 for a list of
possible values - depending on product family.
None
Option Description Default Value
port-name The name of the switch port to be configured.
See Section 2.3 for a list of possible port names.
N/A
rcvlimit The maximum bit rate allowed on a switch port in
the receive direction. See Section 2.3 for a list of
possible values - depending on product family.
None