User guide

Switch command reference Switching
2-25
iMG/RG Software Reference Manual (Switching)
2.2.4.1.28 SWITCH SET PORT INFILTERING
Syntax SWITCH SET PORT <portname> INFILTERING { Enabled | Disabled }
Description This command enables/disables the infiltering process on incoming tagged frames.
When infiltering is enabled, an incoming tagged frame having a VLAN identifier different
from the vlan where the switch port is configured will be dropped.
When infiltering is disabled, an incoming tagged frame having a VLAN identifier different
from the vlan where the switch port is configured is accepted and will be processed
accordingly to the standard forwarding process.
To show the current port status, use the SWITCH SHOW PORT command.
Options The following table gives the range of values for each option which can be specified with
this command and a default value (if applicable).
Example --> switch set port lan1 infiltering disabled
See also SWITCH SHOW PORT
2.2.4.1.29 SWITCH SET PORT MULTICASTLIMIT
Syntax SWITCH SET PORT <portname> MULTICASTLIMIT < mcastlimit >
Description This command specifies the ingress data rate limit for multicast traffic. These limits apply
only to multicast frame types entering on the selected switch port.
To show the current port status, use the SWITCH SHOW PORT command.
Option Description Default Value
port-name The name of the switch port to be configured.
See Section 2.3 for a list of possible port names.
N/A
Enabled | Disabled When Enabled, ingress filtering support is active.
When Disabled, ingress filtering is deactivated.
Enabled