User guide

Switching Switch command reference
iMG/RG Software Reference Manual (Switching)
2-22
2.2.4.1.23 SWITCH SET PORT DEFAULTVID
Syntax SWITCH SET PORT <portname> DEFAULTVID { default_vlanid }
Description This command specifies the vlan identifier used as IEEE Tagged VID added during egress
to untagged frames that arrived at this port. Frames will be processed as frames.
To show the current port status, use the SWITCH SHOW PORT command.
Options The following table gives the range of values for each option which can be specified with
this command and a default value (if applicable).
Example --> switch set port lan1 defaultvid 100
See also SWITCH SHOW PORT
2.2.4.1.24 SWITCH SET PORT DSCP
Syntax SWITCH SET PORT <portname> DSCP { Enabled | Disabled }
Description This command enable the support of DSCP IP field on the incoming frames.
This command is usually used in conjunction with the switch set qos dscp command to
specify on which egress queue an incoming frames having a specific value on the DSCP
field will be forwarded.
When DSCP support is disabled, no specific forwarding policy is applied on incoming
frames except the normal forwarding process.
To show the current port status, use the SWITCH SHOW PORT command.
Option Description Default Value
port-name The name of the switch port to be configured.
See Section 2.3 for a list of possible port names.
N/A
default_vlanid The VLAN identifier to be associated to untagged
frames that arrive to this port. This valid range is
from 1 to 4095.
N/A