User guide

Switching Switch command reference
iMG/RG Software Reference Manual (Switching)
2-20
Example --> switch set port lan1 802.1p Enabled
See also SWITCH SHOW PORT
2.2.4.1.21 SWITCH SET PORT BROADCASTLIMIT
Syntax SWITCH SET PORT <portname> BROADCASTLIMIT < bcastlimit >
This command specifies the ingress data rate limit for broadcast traffic. These limits apply
only to broadcast frame types entering on the selected switch port.
To show the current port status, use the SWITCH SHOW PORT command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> switch set port lan8 broadcastlimit 4Mbps
Enabled | Disabled When Enabled, the incoming packets are placed in
the appropriate priority queue based on the P-Bit
setting.
When Disabled, there is no prioritization based on
P-Bit.
Disabled
default_vlanid The VLAN identifier to be associated to untagged
frames that arrive to this port. This valid range is
from 1 to 4095.
Disabled
Option Description Default Value
port-name The name of the switch port to be configured.
See Section 2.3 for a list of possible port names.
N/A
bcastlimit The maximum bit rate for broadcast traffic that is
allowed on a switch port in the receive direction.
See Section 2.3 for a list of possible values -
depending on product family.
None
Option Description Default Value