User guide

Switching Switch command reference
iMG/RG Software Reference Manual (Switching)
2-14
2.2.4.1.8 SWITCH ENABLE LOOPDETECTION
Syntax SWITCH ENABLE LOOPDETECTION
Description This command turns on the loop detection feature on the switch. The Residential Gate-
way will start sending special “ping” messages to all the switch ports configured as
“coax”.
All the switch ports having a speed valued different from “coax” will not be involved in
the loop detection process.
To add an Ethernet port to the list of ports where loop detection is controlled, use the
SWITCH SET PORT SPEED COAX command.
Example switch enable loopdetection
See also SWITCH DISABLE LOOPDETECTION
SWITCH SHOW
2.2.4.1.9 SWITCH ENABLE PORT
Syntax SWITCH ENABLE PORT <port-name> [FLOW [JAMMING] ]
Description This command enables the selected switch port.
If
SWITCH ENABLE PORT FLOW is entered, pause flow control is enabled when the port
speed is configured to full duplex.
If
SWITCH ENABLE PORT FLOW JAMMING is entered, jamming flow control is enabled when
the port speed is configured to half duplex.
To show the current port status, use the
SWITCH SHOW PORT command.
Please see notes under Port management for the applicability of the FLOW and JAM-
MING options.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
2.2.4.1.10 SWITCH LIST PORTS
Syntax SWITCH LIST PORTS
Option Description Default Value
Port-name The name of the switch port to be configured. See
Section 2.3 for a list of possible port names.
N/A