User guide

Switching Switch command reference
iMG/RG Software Reference Manual (Switching)
2-12
Example switch disable ageingtimer
See also SWITCH ENABLE AGEINGTIMER
SWITCH SHOW
2.2.4.1.3 SWITCH DISABLE LEARNING
Syntax SWITCH DISABLE LEARNING
Description This command stops the learning engine used to update the look up table when frame
are received from new Source Addresses.
To restore the learning process, use the SWITCH ENABLE LEARNING command.
To show the current switch status, use the SWITCH SHOW command.
Example switch disable learning
See also SWITCH ENABLE LEARNING
SWITCH SHOW
2.2.4.1.4 SWITCH DISABLE LOOPDETECTION
Syntax SWITCH DISABLE LOOPDETECTION
Description This command stops the loop detection on the Ethernet ports. Special “ping” messages
used to detect loop are stopped.
Any port that was set to coax mode still remain configured in this mode forcing the port
speed to 10M Full Duplex.
To show the current port status, use the SWITCH SHOW command.
Example switch disable loopdetection
See also SWITCH ENABLE LOOPDETECTION
SWITCH SHOW
2.2.4.1.5 SWITCH DISABLE PORT
Syntax SWITCH DISABLE PORT <port-name> [FLOW JAMMING]
Description This command disables the selected switch port, or disables a flow control mechanism
on the port.
If jamming is specified the jamming signal used for flow control on half duplex ports will
be disabled.
To show the current port status, use the SWITCH SHOW PORT command.