User guide

Switch command reference Switching
2-9
iMG/RG Software Reference Manual (Switching)
23. For 6x6MOD and 7x6MOD devices when 802.1P is Disabled, the P-Bit Setting on any received
packet is converted to 0. So if a packet is received with a P-Bit setting of 3 - the P-Bit of the packet
when transmitted is 0. To assist in managing the implications of this - the default setting for the
WAN and the CPU port 802.1p port attributes is Enabled.
2.2.4 Switch command reference
This section describes the commands available on configure and manage switch ports and the address look up
table.
Throughout are references back to 2.2.3
2.2.4.1 Switch CLI commands
The table below lists the switch commands provided by the CLI:
TABLE 2-2 Switch commands
Commands
Fiber
A
Fiber
B
Fiber
C
Fiber
D
Fiber
E Modular
ADSL
A
ADSL
B
ADSL
C
SWITCH DIAGNOSE PORT
X
SWITCH DISABLE AGEINGTIMER
XX X
SWITCH DISABLE LEARNING
XX X
SWITCH DISABLE LOOPDETECTION
XX X
SWITCH DISABLE PORT
XX X
SWITCH ENABLE AGEINGTIMER
XX X
SWITCH ENABLE LEARNING
XX X
SWITCH ENABLE LOOPDETECTION
XX X
SWITCH ENABLE PORT
XX X
SWITCH LIST PORTS
XXXX XX
SWITCH RESET
XXXXX X X X X
SWITCH RESET COUNTERS
XX X
SWITCH RESET PORT
XXXXX X X X X
SWITCH SET 802.1P PRIORITY
X
SWITCH SET AGE-TIMER
XXXX XX