User guide

ZTC command reference ZTC
1-83
iMG/RG Software Reference Manual (System Configuration)
1.5.3.1.4 ZTCCLIENT SHOW
Syntax ZTCCLIENT SHOW
Description This command shows the ZTC Client configuration parameters.
Example The following example shows the ZTC client parameters when a dynamic configuration is
set.
ZTC CLIENT CONFIGURATION
- GENERAL PARAMETERS
enabled: false
dynamic: true
configuration timeout: 60 seconds
server address in use: 192.168.1.10
- DYNAMIC CONFIGURATION
interface: ip0
- STATIC CONFIGURATION
server address for static configuration: 0.0.0.0
1.5.3.1.5 ZTCCLIENT SET CONFIGTIMEOUT
Syntax ZTCCLIENT SET CONFIGTIMEOUT <configtimeout>
Description This command changes the value of the configtimeout, which is the polling time interval
used by the ztcclient when it check if new configurations are available on the ZTC server.
Options The following table gives the range of values for each option that can be specified with
this command, and a default value (if applicable).
Example --> ztcclient set configtimeout 30
See also ZTCCLIENT SHOW
1.5.3.1.6 ZTCCLIENT SET POLLINGTIMEOUT
Syntax ZTCCLIENT SET POLLINGTIMEOUT <pollingtimeout>
Option Description Default Value
CONFIGTIMEOUT The polling time (in minutes) used by the ztcclient
module when the gateway is already configured.
Acceptable values are from 1 to 120 minutes,
1