User guide

ZTC command reference ZTC
1-81
iMG/RG Software Reference Manual (System Configuration)
1.5.3 ZTC command reference
This section describes the commands available on the gateways to configure and manage the ZTC Client module.
1.5.3.1 ZTC Client commands
The table below lists the ztcclient commands provided by the CLI:
TABLE 1-5 ZTC Client Commands
1.5.3.1.1 ZTCCLIENT ENABLE DYNAMIC
Syntax ZTCCLIENT ENABLE DYNAMIC LISTENINTERFACE <ipinterface>
Description This command enables the ztcclient and binds it on an existing dynamic IP interface. This
command automatically creates a specific configuration rule that applies to the IP inter-
face in order to force the dhcpclient module to request the ZTC server address inside
the option list of the DHCP discover request sent to the external DHCP server.
Note: This command requires that <ipinterface> is defined as dynamic interface, thus it must have the DHCP
flag enabled.
To apply changes to the ZTC client module and turn on it, use the ZTCCLIENT UPDATE
command.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Option
Fiber
A
Fiber
B
Fiber
C
Fiber
D
Fiber
E
Modular
ADSL
A
ADSL
B
ADSL
C
ZTCCLIENT ENABLE DYNAMIC
XXXXX X X X X
ZTCCLIENT ENABLE STATIC
XXXXX X X X X
ZTCCLIENT DISABLE
XXXXX X X X X
ZTCCLIENT SHOW
XXXXX X X X X
ZTCCLIENT SET CONFIGTIMEOUT
XXXXX X X X X
ZTCCLIENT SET POLLINGTIMEOUT
XXXXX X X X X
ZTCCLIENT UPDATE
XXXXX X X X X