User guide

SwUpdate command reference Software update
1-73
iMG/RG Software Reference Manual (System Configuration)
1.4.4.1.8 SWUPDATE START
Syntax SWUPDATE START
Description This command forces the software update to start immediately and remain active until
the next stop command is sent or the download is executed successfully.
Example --> swupdate start
See also SWUPDATE STOP
1.4.4.1.9 SWUPDATE START TIME
Syntax
SWUPDATE START TIME {NONE | MINUTE <minute> HOUR <hour> DAY-OF-
MONTH <day-of-month> MONTH <month> DAY-OF-WEEK <day-of-week> }
Description This command set the scheduled starting time. See the relative section about the syntax
used for the starting time.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Example --> swupdate set start_time minute * hour [0-7] day-of-month
* month * day-of-week *
See also SWUPDATE SHOW
1.4.4.1.10 SWUPDATE STOP
Syntax SWUPDATE STOP
Description This command force the software update to stop immediately and remain in idle state
until a start command is set.
Example --> swupdate stop
Option Description Default Value
MINUTES The minute(s) in the hour when swupdate must start. N/A
HOUR The hour(s) in the day when swupdate must start. N/A
DAY-OF-MONTH The day(s) in the month when swupdate must start. N/A
MONTH The month(s) in the year when swupdate must start. N/A
DAY-OF-WEEK The day(s) in the week when swupdate must start. N/A