User guide

Configuring Alarm Filters Example to Configure Alarm Filter and Actions
AlliedView NMS Administration Guide (Setting Up Fault Management)
9-36
FIGURE 9-20 Alert Filter Configuration Form
This form allows the Administrator to configure both the alert filter (the left side of the screen) and the filter action (the right
side of the screen).
Note: Many of the actions and fields are similar to setting Event Filters, so there are references when appropriate
The user can add, modify, or delete an Alert Filter from the left side of the form. Refer to
Table 9-5.
At least one action needs to be associated with the incoming filtered event. For an event filter, click under filter action to
add one of the action types. These types are explained in 9.5.3.
9.9.2 Example to Configure Alarm Filter and Actions
Adding an alarm filter and an action is done as follows.
Note: An alarm filter must have at least one action.
1. Click in the Event Filter panel.
2. Modify the alert filter name in the left panel as needed and the match criteria fields. If needed, Expressions can be used:
wildcard (*), negation (!), and separators (,). Use the More option if needed.