User guide

Configuring Trap Parsers Task Overview
AlliedView NMS Administration Guide (Setting Up Fault Management)
9-4
FIGURE 9-3 Trap Parser Configuration Form
Select a Trap Parser from the list to see how the fields are configured for that Trap parser. The following table describes these
fields at a general level, as well as the option buttons. Many of the fields will have a variable name, discussed after this table.
TABLE 9-2 Trap Parser Configuration Form
Option Description
Trap Port Port that receives the trap. You must provide at least one, or the traps will not be received. More than
one port can be entered, separated by commas.
Name Name of the trap. The name should match the event.
Nodes Specific nodes for this trap parser. Since most trap parsers are for general conditions or device types,
this field is usually not used.
Groups Grouping of nodes.