User guide

Task Overview Event View
9-3
AlliedView NMS Administration Guide (Setting Up Fault Management)
9.2 Event View
This Event Viewer gets displayed on selecting the Network Events node under Fault Management in the AlliedView NMS
Client Tree as shown in the following figure.
FIGURE 9-2 Network Events Main Panel
Refer to the AlliedView NMS User Guide for general information on navigating in the view and using the search tool.
9.3 Configuring Trap Parsers
Configuring a Trap Parser is done to create and refine the information received from a trap (a specific unsolicited report by a
device).
Configuring Trap Parsers can be done by using the information in the MIB to set the match criteria or defining the configu-
ration and saving it to a file. (This requires that the MIB has been configured to include the traps. Refer to Section 11.)
Note: Trap parsers are critical to alarm correlation and should only be changed under the supervision of Allied
Telesis Technical Support personnel.
To configure the Trap parser, select Edit -> Configure -> Trap Parsers from the main menu of the Network Events Panel.
The Trap Parser Configuration form is shown in the following figure.
Configure Event Parsers Telesis Event Parser Configuration (9.4)
Configure Event Filters Telesis Event Filter Configuration (9.5)
Review Alarm Screen Alarms (9.7)
Alarm Propagation Alarms (9.8)
Configure Alarm Filters Telesis Alarm Filter Configuration (9.9)
Configure System Logs (System Log Configuration) (9.6)
Alarm Retrieval During (Re)Discov-
ery
Retrieve Alarms (9.10)
TABLE 9-1 Task List for Fault Management (Continued)
Task Form/Screen Name (if Applicable) Section