User guide

TEL Ports Power Management System Power Management
7-249
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
7.15.4 TEL Ports Power Management
In 3-8, there is, similar to the LAN Port Power Management, the ability for certain iMG/RGs the ability to configure power
management per voice port, so that a port is automatically disabled in case of power failure. The NMS supports this feature
on iMG/RGs as listed in Table 7-36. Refer to the ATI Gateway Product Family Software Reference Manual for complete
information on this feature and how devices support this feature.
This option is controlled through the Advanced Port Params button on the
• RG Voice Profile - Refer to 7.4.5.
• Service Management Form - iMG/RG -> Voice Service
The following figure shows the Advanced Line Attributes GUI on the Service Management Form.
FIGURE 7-216 Controlling power Management for Voice Lines on Service Management Form
7.15.5 Voice Ports State
Also on the Advanced Line Params for voice service is a read-only field that shows the state of the port:
• Busy - The line is being used. Note that during this state, it cannot be powered down by the Power Management feature
if there is a loss of power.
• Idle - Line is ready to place and receive calls.
• Out of Service - Line has been disabled.