User guide

Provisioning an iMG/RG with the LAN4 FeatureDeprovision the iMG and Re-provision with the ADSL
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
7-236
7.12.6.2 Pre-provision the iMG for ADSL Management
3. If not done already, create profiles for the iMG. If the service/VLAN configuration is the same, the only profile that is dif-
ferent is the General Profile, with the Port Assignments tab having port 4 not set to Management.
4. Fill in the Triple Play Form with the profiles, and select an ADSL port for the Slot.Port, as shown in the following figure.
FIGURE 7-201 Triple Play for ADSL Mgmt
7.12.6.3 Connect the iMG and Power On
5. Connect the customer equipment to one or more LAN ports 1, 2, 3, and 4.
6. Plug the uplink ADSL into the ADSL port.
7. Power on the iMG.
8. Wait and observe how the iMG is discovered, an IP address is found, and the profiles are applied. Refer to the following fig-
ure.
FIGURE 7-202 iMG Provisioned using ADSL (no longer LAN4)
9. Note that in the Customer Details form, the Port Assignments tab now has port 4.