User guide

Procedure - Initial Installation of iMG with LAN4 Provisioning an iMG/RG with the LAN4 Feature
7-233
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
FIGURE 7-196 Triple-Play form Using General Profile for LAN4
4. Review the iMG/RG table. Note that there are still no associated profiles and no IP address, as shown in the following
figure.
FIGURE 7-197 iMG Pre-provisioned
7.12.5.2 Connect the iMG and Power On
5. Connect the customer equipment to one or more LAN ports 1, 2, and 3.
6. Plug the ethernet uplink into LAN4.
7. Power on the iMG.
8. Wait and observe how the iMG is discovered, an IP address is found, and the profiles are applied. Refer to the following
figure.