User guide

Provisioning an iMG/RG with the LAN4 Feature Procedure - Initial Installation of iMG with LAN4
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
7-232
7.12.5 Procedure - Initial Installation of iMG with LAN4
In the following procedure, an iMG634B is pre-provisioned at the NMS; the customer then connects the LAN4 port as the
uplink and then powers up the iMG.
7.12.5.1 Pre-provision the NMS
1. Ensure the correct firmware and bootstrap files available and are loaded using the Boot Load configurator. The following
figure shows how the configurator should be datafilled.
FIGURE 7-195 Boot Configurator for 3-7 Device
2. If not already created, create the relevant profiles that are needed. The only difference between these profiles and the ones
for an ADSL uplink is the Port Assignment tab, as shown in Figure 7-189.
3. Use the Triple-Play form and provision the customer, using the profiles create in Step 2. The uplink port is an FE. Refer to
the following figure.