User guide

Installation Procedures De-Provision iMG/RG from AlliedView NMS
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
7-198
1. Find the RG you wish to de-provision (usually using the Customer ID from the iMG/RG table.).
2. Select the iMG/RG and then Operations -> De-provision Customer iMG/RG. The De-provision Port form appears.
3. Select the Customer ID option for all three panels, then click on De-Provision.
4. The RG will reboot.
5. In the iMG/RG table, the Customer ID is deleted and all profile information is deleted. Refer to Figure 7-154
FIGURE 7-154 iMG/RG Table after Deleting RG
6. To remove the port-RG association, right click on the RG and select Delete Object and Traces. Refer to the following fig-
ure.
Note: If iMG/RG equipment is to remain unprovisioned on this port temporarily (waiting for new customer to move
in etc...), then the deletion of the RG object and traces is optional.
FIGURE 7-155 Delete RG-Port Association (Delete Object and Traces)
7. The user can now either:
• Place the iMG/RG back in its box for storage. When the RG is reconnected, it must be to a port in the same Access
Island.
• Transfer the RG to another iMAP port in the same Access Island.
8. End of Procedure.
7.10.9.3 De provision the iMG/RG (Different Access Island)
1. Find the RG you wish to de-provision (usually using the Customer ID from the iMG/RG table.).
2. Select the iMG/RG and then Operations -> De-provision Customer iMG/RG. The De-provision Port form appears.