User guide

Provision a new Customer (out of the box) - Triple Play Installation Procedures
7-177
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
FIGURE 7-135 IMG/RG Table - iMAP Port Configured, no iMG/RG Configured
Note the following:
• The Customer ID, Type (Family level), and Upstream Port are identified.
• The iMG/RG IP address, software release, and associated profiles are not included. These are filled in as a result of
plugging in the iMG/RG by the customer, which begins the DHCP configuration steps.
15. End of this part of the Procedure
7.10.4.4 Install the iMG/RG and Apply Power
Note: Installation instructions are included with the iMG/RG packaging, and these should be read before
continuing with this part of the Procedure, since these instructions will include detailed pictures, a listing
of cables that are used for the interface connections, and any updates to product information.
Note: If a technician is installing the Ethernet version of the iMG/RG, a PC (laptop) can be connected directly to
monitor the progress of the iMG/RG configuration (mainly the successful allocation of addresses by
DHCP). The console cable is sold separately by ATI. Use n-8-1-38400 for the console port setting.
For this part of the procedure, do the following:
1. Ensure the connection to the customer from the iMAP connection is active.
2. Remove the iMG/RG from its packaging.
3. Connect the WAN cable to the external interface port.
4. Apply power to the iMG/RG (usually by connecting the power cable to iMG/RG and then plugging it in).
5. Note the sequence of events that shows the iMG/RG as run through its initial and reboot sequence (for details refer to
7.2.6.5).
7.10.4.5 Connect Devices and wait for Services to Begin
1. Note which ports are being used:
• LAN1 to a STB for video service
• LAN2 to a PC for internet service
• LAN3 - Unused
• TEL1 - to a telephone for voice service
• TEL2 - Unused
2. Connect the devices to the iMG/RG using the appropriate cables.
3. Once connected, devices will use DHCP and the provisioned components. When finished, all devices should be provid-
ing service. Test all devices to ensure they deliver the promised service(s).
4. END OF PROCEDURE