User guide

Changing VoIP Endpoint Syntax Provisioning Guidelines for Models
7-163
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
7.9.7 Changing VoIP Endpoint Syntax
As described in 7.4.5, for MGCP configurations that do not use GenBand, there is the option in the RG Voice profile to enter
the VoIP endpoint that will be used. On the service management form for the iMG (iMG/RG -> Voice Service) there is the
option of entering the endpoint syntax by selecting the Syntax checkbox and then filling in the iMG/RG Domain using the @
for the specific settings for the voice endpoint (@$IP, @$MAC, @$HOST, etc.). Refer to the following figure.
Note: The NMS supplies the “aaln/<telport number>”at the beginning of the string, and then the user continues
the value with @. Therefore, values form vendors that do not follow this format are not supported, such
as “$MAC:aaln/0@[$IP]”. Modifying the end-point syntax is an advanced setting and should not be used
unless required by the MGCP server.
FIGURE 7-125 Setting VoIP Endpoint Syntax