User guide

Provisioning Guidelines for Models iMG7x6MOD
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
7-152
For existing Ethernet port profiles these changes are not an issue, because they will not have the port direction field explicitly
set. However, new port profiles should be created with the port direction set to match the provisioning scenario in which
they will be used, as follows:
The following iMAP GE ports should have new profiles set with the direction of Customer when connecting with the AT-
iMG7x6MOD:
• GE8 on the 9x00 iMAP
• GE4 (5.0-5.3) on the iMAP 910x
• GE24BX on 9000 series iMAP
• GE24SFP on SBx3112
Caution: Modifying an existing ethernet port profile is possible but carries risks, since you will now set the
port direction. Setting it to ‘Customer’ for an existing Ethernet port may stop service. Setting it to
‘Network’ on an FE/FX port with an iMG/RG (where the administrator could set the port direction to
‘Customer’ at the CLI) will cause the DHCP to no longer function.
Refer to the following figures.
FIGURE 7-116 Provision New Triple Play Form for GE8/GE24BX/AW+/GE24SFP Port