User guide

Configuration 8 - AlliedWare Plus Device Datafilling the Triple Play Form - Examples
7-113
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
The Triple-Play form can be used to pre-provision the iMG/RG using the already created Profiles. The Triple-Play form is
filled out as with other upstream devices, as shown Figure 7-85.
The few points to note in configuring iMG/RGs to AlliedWare Plus devices are:
• In 12.1, when an AW+ product is first installed, you must use NMS to deprovision the ports before provisioning the
ports. This is because they have default descriptions (CustomerID) such as port1.2.4, as shown in the following figure.
FIGURE 7-84 Provisioning Ports on AlliedWare Plus Devices
Note: After the ports have been provisioned with the NMS, then de-provisioned, their customer ids remain
blank. Over time all non-provisioned ports will be blank. It's only when the device is newly installed that
they have default descriptions and require this extra de-provisioning step.
• Upstream port numbering - These use the 3-number format (for stack.module.port)
• Each AlliedWare Plus device must function as an L3 Router.
• Customers on each switch must be in non-shared subnets, because these AlliedWare Plus devices do standard DHCP
Relay with option 82 as circuit ID only (no remote ID) and do not perform DHCP Snooping.