User guide

Basic Configurations with Sample Profiles ADSL iMG with multiple VCs
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
7-78
7.5.9 ADSL iMG with multiple VCs
The user can provision the iMG/RG General Profile and ADSL Port Profile so that the ADSL-based iMG/RG can support ser-
vice VLANs with different VC configurations. The format used to specify a specific VLAN/VC combination is
<vlanid>
vc:<vpi>.<vci>:<tagged or untagged>.
In the following figure, the RG General Profile has the internet VLAN config-
ured on a different VC with VPI=0 and VCI=36. An ADSL port profile is then created to match that setting, as well as the
transmit rates.
FIGURE 7-48 The RG General and ADSL Port Profile to Support VLAN/VC Configuration
When the user then fills out the Triple-Play form for the ADSL-based iMG/RG, and uses these profiles, the VLAN/VC settings
will be set immediately on the iMAP, and on the iMG/RG when it placed into service (connected and powered on). The follow-
ing figure shows a Triple-Play form that uses the profiles that will have the iMG/RG come up with the internet VLAN having a
different VC and transmit rate, as shown in Figure 7-48.
Note: The attributes on the iMG/RG General Profile, Port Profile, and Service Profile must match. Otherwise,
when the user fills out and submits the Triple Play form, it will fail with the error message that the profiles
don’t match. (If these profiles were to be applied, traffic would not pass on the internet VLAN.) This is
shown next.