User guide

Creating RG Profiles with Field Descriptions Video Profile
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
7-52
TABLE 7-13 Create RG Video Port Profile Form
Attribute Value
Profile Name A descriptive name that should match the service/function provided
Example Names:
Flood - This would match the NONE for IGMP Mode (IGMP Snooping
turned off)
Snoop (646 and 656) - Note that all RG600 series RG/IMG will support
snooping in the next sw release.
Proxy - The RG performs the IGMP function. Possible Names are:
(These are for ADSL only)
ManualSec2/Proxy (up to two STBs and must specify STN MAC
address)
ManualSec3/Proxy (up to three STBs)
AutoSec2/Proxy (up to two STBs and STB sends its MAC address)
AutoSec3/Proxy (up to three STBs)
(These will be available in future releases as they are supported.)
ManualSec2/Snoop
ManualSec3/Snoop
AutoSec2/Snoop
AutoSec3/Snoop
Include Video VLAN in Profile The value entered here depends on the network model:
False - The Access Island model is used, and the Internet VLAN Id field is blank.
True - The Open Access model is used, and the Internet VLAN Id field is activated.
iMG/RG Video VLAN Id The VLAN that supports internet service.
If the ‘Include Video VLAN in Profile’ is set to True, this field is activated.
Use DHCP to obtain WAN IP
Address
Used for the Media Room feature. Refer to 7.6.10.3.
IGMP Mode None
Snooping
Proxy
Multicast Acceleration Used for the Media Room feature. Refer to 7.6.10.3.
IGMP Time-out Number of seconds before channel is dropped because of no IGMP message.
The IGMP time-out must be at least 10 seconds greater than the router queries, but not
so much higher that it will time-out.
IGMP Leave Time (0..255) Time in seconds between when the Leave message form the last host is received and
the multicast connection is dropped.