User guide

Creating RG Profiles with Field Descriptions RG Internet Profile
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
7-40
Local DHCP Start IP Address The first address in the range for a local device in the local network. This possible
range must be derived from the Local IP Address and the Local Mask.
Local DHCP End IP Address The last address in the range for a local device in the local network.
Rate Limiting (CPU-based) Enable or Disable Rate Limiting
When enabled, the upstream and downstream attributes (Rate Limit, Burst Size) are
editable.
The downstream rate limiting applies to Internet VLAN traffic and is used for wire-
less traffic because the downstream rates are applied on WAN port when the traffic
enters the iMG.
Upstream rate limiting applies to Local VLAN traffic which applies to LAN ports
but not wireless because classifiers are applied on the transport and the wireless
transport is not the same as LAN transport.
However, for certain wireless IMG 3.8 devices, you can configure the upstream rate
limits. Note that the NMS will use the same rate limits values that are currently set
for wired ports on wireless. The devices that support this are:
• iMG616-W
• iMG634-A-W-R2
• iMG634-B-W-R2
These fields can also be changed on the Service Management Form for these
wireless devices.
Scaler Represents the weight of each byte of data coming over the channel. The higher the
scaler value the lower the worth each byte of data is counted for rate limiting pur-
poses. This allows a more precise reflection of actual network traffic.
Copy values from profile To create a new profile, the user can select an existing profile, which will fill in the
values from that existing profile. The user can then modify any fields.
Create Activated when a Profile Name has been typed, it creates the profile with the entered
values.
Cancel Closes the window
TABLE 7-9 Create RG Internet Port Profile Form
Attribute Value