User guide

Creating RG Profiles with Field Descriptions Overview
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
7-28
7.4 Creating RG Profiles with Field Descriptions
7.4.1 Overview
7.4.1.1 Pre-requisite Steps
Before Profiles can be created, the administrator has already done the following:
• The DHCP servers and DNS servers have been set up
• Routing has been set up
• The G6 setup and if required with the IP address of BBI and AI's default router IP for voice subnet
• Knowledge of the “back office” management subnets
• Knowledge of the vpn “back office” management subnet
Note: These “back office” subnets are separate subnets that ensure that it is possible to communicate with the
RG. These require separate routes as well. Refer to 7.4.2.
• The service VLANs have been set up on the relevant iMAPs.
• Set of RG Profile names that will be used. For General RG Profiles the following shows the naming convention.
For Access Island 1 (AI01)
• DVLKND-AI01-P_1I_1V (Phone, 1 Internet, 1 video)
• DVLKND-AI01-P_1I_2V (Phone, 1 Internet, 2 video)
For Access Island 1:
• DVLKND-AI01_1I_2V (1 Internet, 2 video)
• DVLKND-AI01_1I_3V (1 Internet, 3 video
• etc....
Note: Because rate limiting may be a factor the name may need to highlight this as well.
Note: “Packaged” marketing terms may also be appropriate names here, such as “DVLK-AI01-DSLPro+VVid”
7.4.1.2 Profile Fields and Provisioning Models
As the fields for the RG forms are described, there are notes and further details when the data fill is particularly important for a
configuration type (Access Island, Open Access, Multi-service VLAN, Security, etc.)
7.4.2 General Profile
The RG General Profile contains the high level attributes for the RG so that it can support a set of services (data, video, voice).
The names that are given to the profiles should match the service set that the RG is supporting.
Note: For each service, there is a separate profile that defines the specific attributes for that service.
To create a General profile, select Network Services -> Profile -> Create RG General Port Profile. The Create Profile Form
will appear with the fields that apply for the RG General Profile. Refer to the following figures and tables.