User guide

Feature List for Release 12 (up through SP1) Overview
7-3
AlliedView NMS Administration Guide (Provisioning the iMG/RG)
iMG GR909 Diag-
nostics
For the iMG6x6MOD and iMG7x6MOD with at least release 3-
7.4, voice lines can be enabled/disabled, and internal/external
diagnostics can be run.
Refer to 7.14.1
iMG/RG LAN Diag-
nostics
For the iMG6x6MOD and iMG7x6MOD with at least release 3-7,
diagnostics on LAN ports can be run.
Refer to 7.14.2.
Support of iMG/RG
with 3-8 release
(SP1)
The NMS will support all of the iMG/RGs that are available with
the 3-8 release.
MPEG Testing
(SP1)
In release 3-8, all iMG/RGs support MPEG testing. The NMS
supports this feature, and retains the same functionality for MPEG
testing for previous iMG/RG releases.
MPEG testing from the NMS is expanded; all 3-8 iMG/RGs sup-
port MPEG testing, and the MPEG test on all devices can be run
by the NMS.
When running the MPEG test in Snooping mode, the video IP
interface must not be the 0.0.0.0 default.
Refer to 5.3.14.
Provision iMG/RG
connected to Allied-
Ware Plus devices
(SP1)
The same provisioning strategy and GUIs are used for provision-
ing iMG/RGs to AlliedWare Plus devices as to iMAP devices.
(Provision using the Triple Play Customer Form, customer ID is
the same for both AlliedWare Plus port as the iMG/RG, etc.)
Triple Play Form, refer to
7.6.9
System Power Man-
agement on 3-8
iMG/RGs
(SP1)
This feature helps to extend the battery life during power loss.
When enabled, specified ports immediately shut down, usually so
that services such as lifeline POTS can continue as long as possi-
ble. For each device there are various levels of support.
RG General Profile,
RG Voice Profile,
Refer to 7.15.
Enhanced FAX/
modem detection
(SP1)
The NMS did not support this feature in previous releases (default
of Enabled). In R12SP1, the feature is added as well as including
the 3-8 feature ENHANCED, in which the software will automat-
ically change the mode depending on the incoming signal.
RG Voice Profile, refer to
7.4.5.
Setting Call Waiting
Activate/Deactivate
Prefix (SIP)
(SP1)
This feature was in 3-7 devices, and the NMS in R12SP1 has
these added.
Voice Profile, refer to 7.4.5
Wireless Upstream
Rate Limiting
(SP1)
For wireless devices, the iMG allows configuring upstream rate
limits. The NMS will also allow rate limiting, but the rate limits
will apply to both
wired and wireless ports. This is for:
• iMG616-W
• iMG634-A-W-R2
• iMG634-B-W-R2
RG Internet Profile, refer to
Section 7.4.3
Support of 40km
Optics Module
(SP1)
Both the iMG6x6MOD and iMG7x6MOD support the Fiber card
that has 40km optical reach.
None - All GUIs are the
same.
Support of
HPNA320 card
(SP1)
This is an enhanced HPNA card that is only for the
iMG7x6MOD.
None - All GUIs are the
same.
TABLE 7-2 Summary of iMG/RG Release Features in Release 12 (Continued)
Feature Description GUI to Access / Reference