User guide

Upstream Control Protocol (UCP) Display Events View (Change of State)
AlliedView NMS Administration Guide (Configuring Network Services)
6-236
FIGURE 6-239 UCP Status in the Network Inventory Table for the VLAN Interfaces (Highlighted)
6.18.3 Events View (Change of State)
When the active/standby status of the Primary/Secondary Node changes (because of failures in the network or administrative
changes), SNMP traps are sent from the device indicating a state change. In the Events view, they appear as Info status events.
The following figures show how these changes are displayed.
FIGURE 6-240 Events View when Change in UCP State (Highlighted)
Note: Since Events are part of Alarm Management, these events can be modified going through the Events Filter
and can trigger various other events/alarms. Refer to Section 9.
These changes are also reflected in the VLANIF submap and the VLAN Interfaces Network Inventory table.
Note: To ensure that the status of the VLANs/interfaces is correct, the user can rediscover the relevant devices.
This will appear in the Event view as a rediscovery, but if there are UCP-related changes, they will appear
in the VLAN submap and Network Inventory table.