User guide

Adding PPPs to the MLPPP NTE8 Dual Circuit Provisioning
6-223
AlliedView NMS Administration Guide (Configuring Network Services)
FIGURE 6-226 Result of Success (Fields Ready for next Customer)
6.17.5 Adding PPPs to the MLPPP
Once the NTE8 DS1 circuit has been set up, with a PPP and associated MLPPP at each end, the user can add DS1s/PPPs to
the existing MLPPPs. By filling out the NTE provisioning forms, the user can ensure the provisioning goes smoothly and the
correct parameters are entered.
Refer to the following figure while reading below.
To provision the second DS1s/PPPs, right click on the relevant device, in this case the .49 device, and select Provision ->
Port Management. In the Port Management form, select the DS1 that is going to be added (in this case, 14.1). This PPP is
being added to MLPPP 14.8, so the user chooses this MLPPP from the pull-down. Note that the MLPPP already contains the
PPP 14.0 and has already been configured (LINK).
Once the user chooses this MLPPP, the peer MLPPP is automatically datafilled in, since in any set of PPP pairs, the PPPs on
one side must have the same peer MLPPP.