User guide

SuperLoop Prevention (Superring) Creating the EPSR SuperRIng
AlliedView NMS Administration Guide (Configuring Network Services)
6-164
FIGURE 6-151 Configure EPS Control Ring Panel
The Network VLAN should be highlighted on the left panel. (If not select the loop Network VLAN), then select “Create Pro-
tection Domain”. This brings up the Create New VLAN Protection Domain Dialog Form, as shown in the following figure.
FIGURE 6-152 Create New VLAN Protection Domain Dialog (Initial)
Enter the Protection Domain Name = jptDom710 and the EPSR Priority=126. By putting in a non-zero value, the user
intends to use the this EPS Ring in a SuperRing configuration. Finish by selecting OK, and the system will show how the
devices will be configured. Refer to the following figures.