User guide

Troubleshooting Policies and Profile Management Redeploying Policies
AlliedView NMS Administration Guide (Configuring Network Services)
6-132
FIGURE 6-111 Redeploy Policy
Clicking on Finish at this point will redeploy the policy for that device. Clicking on Next brings up the Select Deployments
form. This allows the user to redeploy a policy to the set of devices that have the policy deployed and to schedule the redeploy-
ment. Refer to the following figure.
The table includes all the devices that have the policy. One column, Status, is the relationship between the policy and the
device:
• Policy Changed - The policy has changed, but the device policy does not match.
• Device Changed - The policy on the device has changed, but the policy has not changed.
• No changes - As far as what has been configured, there have been no changes.
The Auto Selection panel can be used to redeploy the policy to all the devices (by not checking any tic boxes) or selecting only
those devices that are in these states (checking the tic boxes).
Selecting Finish starts the task immediately, while selecting Next will allow the task to be added to a schedule.
Note: In most situations, redeploying a policy is done more efficiently by changing the policy and redeploying the
profiles that use that policy.