User guide

Profile Management DS3 SFP Support
AlliedView NMS Administration Guide (Configuring Network Services)
6-80
• Up if an SFP has been inserted and both interfaces are operationally up.
Note: For traffic to flow, both the DS3 and GE interfaces must be operationally up, and any condition that causes
one to go operationally down (such as an alarm or being administratively disabled) will cause the other to
go operationally down with a failing condition and alarm.
Once the port is provisioned, you can review the in the Service Management Details for the port. This is similar to other Ether-
net ports except for the following:
• General - The state of the DS3 link. Note that the relationship between the DS3 and the associated GE interface is associa-
tive rather than parent/child. Refer to the iMAP User Guide for more information. Refer to the following figure.
FIGURE 6-79 DS3 - EtherLike Configuration, General Tab
• DS3-SFP - This is under the Ether-like Configuration tab, and not only the DS3-SFP settings, but the setting of the Loop-
back Status. If set to On, the Loopback Type and Location are activated and can be set.
Note: The port must be operationally down to set a loopback.
Refer to the following figure.