User guide

Profile Management Redeploying a Profile
AlliedView NMS Administration Guide (Configuring Network Services)
6-64
FIGURE 6-60 Deply on iMG/RG
6.10.6 Redeploying a Profile
There are times when a user needs to re-synchronize the parameters stored in the Profile on the NMS with the configuration of
the actual devices or ports in the network. This could be needed after a change is made to the Profile, or when the user wants to
reset any temporary changes made to individual ports in the network back to the Profile configuration. To re-apply or re-deploy
a profile to the network, follow these steps:
1. Bring up the Profile Deployment window for a device or port. (Refer to Figure 6-58 and Figure 6-59.)
2. To re-deploy Port Profiles select Apply to ports with Profile port selection method.
3. To re-deploy Device Profiles select Apply to devices with Profile device selection method.
4. Select the current profile.
5. Press the Deploy button.
6. The NMS will start a Task to reset all the parameters on the appropriate device(s) or port(s) to match those defined in the
Profile.
Note: The NMS will only set parameters where the value on the device differs for the value in the Profile.
6.10.7 Scheduling Deployment of a Profile
There are situations where a Profile should be deployed at a particular time in the future (such as pending service activation) or
at regular intervals (such as switching back and forth between two Profiles based on time of day or day of week). To schedule
the deployment of a profile follow these steps:
1. Sets up a profile deployment.
2. Instead of pressing the Deploy button, press the Next button to bring up the scheduling window. Refer to
3. Select One Time schedule or Recurring schedule and the appropriate parameters for each.