User guide

Example Configurations for HVLAN, Translations VLAN Translations Configuration
AlliedView NMS Administration Guide (Configuring Network Services)
6-52
6.9.3 VLAN Translations Configuration
6.9.3.1 Setting up VLAN Translations
To set up VLAN translations, the basic sequence is:
1. Create the VLAN that will become the translated VLAN that will go through the network.
2. Associate this translated VLAN with the appropriate interfaces, both on the customer side (where the translation will take
place), and the network side (as the translated VLAN goes through the network).
3. Set the translated VLAN option, as shown in the following figure.
FIGURE 6-52 Port Profile with Translations Options
The values entered are 20=201,40=901,10 (This would be an example for an iMG6x6MOD).
6.9.3.2 Restrictions
Keep the following configuration guidelines in mind when provisioning Translation VLANs:
Note: For more details on the VLAN Translations feature, refer to the Feature Guide.
• The following cards support VLAN translation:
• GE3, XE1, GE8 (network interfaces) Refer below for FE10/FX10/FX20.