User guide

Example Configurations for HVLAN, Translations HVLAN Configuration
AlliedView NMS Administration Guide (Configuring Network Services)
6-50
FIGURE 6-50 Test Network VLAN Form (Finish to run Test)
FIGURE 6-51 Testing Results for the HVLAN Configuration
Extending this HVLAN configuration usually involves adding another iMAP 9000 device with service ports that support mul-
tiple VLANs on its untagged ports. The steps are similar to the steps in 6.8.2, where the user usually creates a link to another
device from the VLAN Network node (in the example this would be the VLAN502[51] node). The user then right-clicks on the
device in the VLAN that has the new link and selects Extend VLAN. The link would be selected.
Clicking on Next would bring up the Select/Create Vlan Interface Form, and the user would select the Create VIF button.
This form is shown in the Overview (Figure 6-1), and the VlanID (502) would be given the type HVLAN. After pressing OK,