User guide

Customer Cutover Procedure Example - Transfer of iMG to different Port
AlliedView NMS Administration Guide (Controlling and Provisioning Network Devices)
5-262
The user first brings up the Port Management Form for the source device and highlights the appropriate source ports, which
must be provisioned ports with a Customer ID, as shown in the following figure.
FIGURE 5-241 Selecting Source Ports for iMG/RG Cutover
The user then clicks on the Cut-Over Customer button. The Customer Cut-Over Panel appears, with the Source Device, Ports,
Types, and Customer IDs filled in.
The user selects the Destination Device from the pull-down (in this case the same as Source Device), which makes the ports in
the Dest column available for selection. The user has the option to select non-sequential ports, but in the example the user has
selected ports 0 through 5 on card 8. Refer to the following figure.