User guide

Customer Cutover Procedure Example - Transfer to different cardtype
AlliedView NMS Administration Guide (Controlling and Provisioning Network Devices)
5-258
In most cases, the destination has a one-to-one mapping between ports on the card. However, the user is free to select various
destination ports, as shown in the following figure.
Note: Although the destination ports are valid since they are the same type, the NMS will produce an error
message if the user tries to transfer an Annexed port to a non-Annexed port.
FIGURE 5-238 Ability to Choose any Valid Destination Port
The user then selects the Provision Destination button. The NMS now validates the source and destination ports and displays
the status of the transfer as the task completes. Refer to the following figure.
FIGURE 5-239 NMS Provisioning the Destination Ports