User guide

Procedure Example - Transfer to different cardtype Customer Cutover
5-255
AlliedView NMS Administration Guide (Controlling and Provisioning Network Devices)
5.11.4 Procedure Example - Transfer to different cardtype
In this example, the user wishes to transfer the 24 ports of an ADSL24 card to an ADSL48A card. (This example would be
fairly typical, since many system upgrades involve installing ADSL48A cards and transferring over existing ports.)
5.11.4.1 Copy the Port Attributes from the Original Ports to the new Ports
Figure 5-234 shows the initial configuration, using the card and port management forms for the source and target iMAPs.
The 60.80 iMAP is the source device and the 30.34 iMAP is the target device.
FIGURE 5-234 Cutover - Initial Configuration
The user selects in the source device the port(s) that are going to be cutover. In most cases these will be the contiguous ports
on a card. When the ports are selected, the Cut-Over Customer button is activated, as shown in the following figure.