User guide

Support of CWMP with TR-069 Devices Port Management (non-iMAP Devices)
5-225
AlliedView NMS Administration Guide (Controlling and Provisioning Network Devices)
5.7.6 Support of CWMP with TR-069 Devices
Caution: Caution: Due to inter operability problems, do NOT use the TR-069 CPE WAN Management
Protocol (CWMP) to manage Comtrend 5631 CPE. Otherwise, service may be interrupted.
Instead, use the Comtrend web GUI for configuration and management. Contact your ATI
representative for details.
5.7.6.1 Overview
Support of CWMP with TR-069 provides:
• The CPE Wan Management Protocol (CWMP) TR-069 framework is supported.
• Basic support for the Comtrend 5631 CPE device.
This Comtrend device supports bonded ports where multiple ADSL lines are combined (bonded) together and connected to
one CPE device to allow higher throughput rates for the individual customer using the CPE. The feature to support provi-
sioning bonded ports (G.bond) is already supported in the NMS release, and is described in 5.6.31. This NMS feature is
expected to be used to configure the iMAP ports where the Comtrend CPE is connected. Refer to the following figure, keep-
ing in mind the following provisioning guidelines:
• The G.bond feature requires support for up to two (2) ADSL bonded ports.
• Unlike the SHDSL wire-pair bonding implementation which requires the bonded ports to be adjacent, G.bond allows for
any two ports to bond together as long as they exist on the same card.
FIGURE 5-208 Comtrend Configuration (Bonded ADSL)